 |
 |
 |
|||
|
|
|
|
|||
 |
 |
||||
|
|
|||||
 |
|
|
|
|
|
|
For a printable version of
these instructions click here Hoofwing Instructions |
|||||||||||||||||||||||
|
Step 1. Draw the Outlines |
|||||||||||||||||||||||
|
Have these materials ready before you begin: Two sharp
pencils, (one pencil must be short enough to pass under the
horses fetlock). Several pieces of 8-1/2" x 11" white paper. A
smooth level surface. (A piece of plywood 14" x 17" is
adequate).
|
|||||||||||||||||||||||
| To
draw an accurate
outline of a hoof hold the pencil straight up and down.
It helps to, "eye" down the pencil. Tip: Have a helper hold up the horse's opposite leg |
|
||||||||||||||||||||||
|
When drawing the back of
the
weight bearing surface angle the pencil. Tip: Move the pencil back and forth several times to get a good line. |
|
||||||||||||||||||||||
|
Draw the outline of the bulbs. Use the short pencil. Hold the pencil straight up and down as you draw the bulbs.
|
|
||||||||||||||||||||||
|
Note the weight bearing and the outline of the bulb lines. Indicate with initials, (LF, RF, RH, LH) which hoof the outline
|
|
||||||||||||||||||||||
|
Measure across the
widest part of the outline. Draw a line to indicate that
measurement. Write that measurement on the line. |
|||||||||||||||||||||||
|
|
|||||||||||||||||||||||
| Measure from the toe back to the weight bearing line and indicate that measurement. |
|
||||||||||||||||||||||
|
"Wing' measurement. This 'wing' measures 15 inches. |
|||||||||||||||||||||||
|
Height of coronet band at back of bulb. |
|||||||||||||||||||||||
|
Length of bulb. (measure from back of ankle to back of bulb at coronet band). |
|||||||||||||||||||||||
|
Fax the outlines and measurements to: 520-455-5171. Mail to: HorseSneaker Hoof Boots P.O. Box 433 Sonoita, AZ 85637 Ship to: 45 Hitchcock Lane Sonoita, AZ 85637 |
|||||||||||||||||||||||
| Back to top Home page | |||||||||||||||||||||||
